Hello! We are John and Kody, and we are going to be relaying to you the knowledge and uses of polymers in the cleaning and filtration of water to be used or released back into the environment. We will be talking about where in the process they are used, their properties/effect, and which ones are used.

Water treatment

A general water treatment process goes through a particular set of steps and steps can be added or omitted if need be based on the treatment process. First water flows into a tank for primary clarification. Clarification is the process by which solids are allowed to settle, which eliminates a good chunk of the solids in the water. Since many are tiny and are not heavy enough to resist buoyancy factors, chemicals must be added to get them to stick together and clarify out.


Coagulants remove or add electrical charges, which allow the particles to stick together.  Most particles in a typical solution of water that requires treatment are negatively charged particles.This process is called flocculation. A variety of things could be used as a coagulant which includes polymers.

After flocculation of these particles occur they travel to a secondary clarifier to settle out.

coagulant 1

coagulant 2


There are different types of polymers that are used in water treatment. They can be stored and transported in different forms.

There is a dry powdered form which is easy and cheap to transport but it is often difficult to mix, requiring special equipment to process it into solution form.

There is a liquid form which is a concentrated solution of a polymer which only requires diluting to use, but it is more difficult and possibly more expensive to transport.

And finally there is an emulsion form which are polymer dissolved in droplets of water in oil. These are not 100% active and can separate out over time which requires occasional mixing. The upside is these can account for various charges in treatment.

Which polymers are used?

There are a few major types of polymers used and then there are some minor ones used as well.


Polyamines   –   nonionic bridge particles together. Anionic and cationic formed by copolymerizing with acrylic acid or cationic monomer.

Poly (Diallyl Dimethyl Ammonium Chloride) – similar to polyamines but can be copolymerized with other monomers.

Polyacrylamides – usable in various pHs




Polysaccharides – guar gums, used in acid